Sign Up
Color Core Solid Phenolic
Fabricated Sheet

In Stock Student or Instructor Benches

Black 1" Thick, 1/8" Bevel with Eased Corners
No Cut-Outs Provided

  • FLAT-48X24
  • FLAT-48x30
  • FLAT-48x36
  • FLAT-54x21
  • FLAT-54X24
  • FLAT-60x24
  • FLAT-60x30
  • FLAT-72x24
  • FLAT-72x30

Fabricated Epoxy Sheets

FABRICATED WORK SURFACES, factory cut in accordance with approved shop drawings, are typically known in the industry as "Universal" countertops and are equivalent in detail to "Classic Tops" when fabricated with a 1/8” (3mm) to 1/4” (6mm) Radius or standard 1/16” (1.59mm) to 1/8” (3mm) Bevel or chamfer. Other fabrication detail includes sanded edges, along with sink cutouts (lipped or undercounter mount), waterfall edge, marine edge, drip groove, set-on or integral coved backsplash, faucet and gas tap holes, notches, electrical box cutouts, column cutouts, etc., all offered at an additional modification charge. Duratop Epoxy is provided without pre-prepped area for splines and spline materials are not provided with fabricated sheets.

Thickness tolerance for all surfaces, fabricated or slabs, from each corner of top, shall not deviate more than plus / minus 1/32" (1.5mm overall) from normal, per Laboratory Work Surfaces & Accessory design specifications, section 12345. Size tolerance in epoxy counter tops shall be plus / minus 1/8" (3.175mm). Applied Epoxy joints between sheets should not exceed 1/8" (3.175mm).

According to Specification, secure epoxy countertops to cabinets with Duratop Epoxy Smooth-On 2-part adhesive cement, applied at each corner and along perimeter edges at not more than 48 inches (1219mm) on center. When necessary to penetrate countertops with fasteners, countersink heads approximately 1/8" (3mm) and plug hole flush with material equal to countertop in chemical resistance, hardness and appearance

Architectural Specifications for work surfaces shall be either 3/4" (19mm) or 1” (25mm) thick molded composite thermosetting epoxy. A maximum of 1.25" (32mm) can be molded as a one-piece monolithic sheet. The Duratop epoxy surface finish shall have a non-glare satin finish. All exposed edges shall be eased to the specified radius, bevel or chamfer. All front overhang edges of 1" (25mm) on the work surface shall be factory machined to have a 1/8” x 1/8” drip groove on front underside at a distance of approximately ½” (13mm) from the outside edge. All holes for sinks and fittings shall be factory cut with a CNC Router. Splash backs and sides shall be the same material and finished as the work surface. Splash backs shall be ¾” or 1" thick, supplied cut to size, and shipped loose for field installation. All joints between unfinished sections of tops shall be butt jointed and bonded on site with an approved bonding agent such as Smooth-On Epoxy Adhesive joint compound to ensure a smooth water tight joint. Laboratory countertops shall be maintained regularly with common non-abrasive household cleaner. After cleaning, a light application of Scott's Liquid Gold or similar mineral oil will help protect the surface. Spills shall be cleaned immediately.